Dantherm CDP 50 - High Pressure Fail; Service Alarm; Alarm Priority

46
EN
High pressure fail
Dehumidier has stopped because of High Pressure detection.
Fail can not be dismissed from Remote panel.
It is not allowed to enter menu setup for modication of set points values.
Service alarm
The Service icon will be shown when it is time for servicing the dehumidier.
The service alarm does not aect the operation of dehumidier.
To dismiss/reset service alarm:
- Press right for 5 seconds to enter the installer menu.
- Press DOWN/UP to navigate to service icon.
- Press RIGHT/LEFT to change setpoint from 0 to desired service interval.
- Conrm service interval by pressing enter.
Alarms priority
Press for 5 seconds
to enter installer
menu setup
HP
LP
SEnS
Abt
Abrh
High priority
Low priority
When more than one alarm is active the list above
shows the priority of the alarms.
Alarms continued