Dantherm CDP 70 - Page 9

9
OFF
CDP 40/50/70T
i
Surface appearance according to reference
g
SCALE: NOT TO SCALE
3
5
1
5
1
6
351516
MATERIAL:
THICKNESS:
WEIGHT:
REV. BY:
DATE:
REF.:
DATE:
PART NO REV.:
R
E
V
.:
P
A
R
T
N
O
table LZT 142 0001, category process equipment and is only entended as a guide.
CDP-T Small
CDP-T Small
8
Sheetmetal flatstate is based on Dantherm Air Handling A/S
All designs originated by Dantherm Air Handling A/S are the
property of said Company and will be protected by Patents.
This Drawing is furnished with the understanding that the
essence there of will not be reproduced in whole or in part
without written authorization by Dantherm Air Handling A/S.
Linear dimensions without tolerances according to
DS/EN 22768-1 medium. Angular dimensions without tolerances: ± 1°
V
431
59
Ø3/4”
700
294
307
80
W
89
73 80
426 36
Surface appearance according to reference
g
SCALE: NOT TO SCALE
3
5
1
5
1
6
351516
MATERIAL:
THICKNESS:
WEIGHT:
REV. BY:
DATE:
REF.:
DATE:
PART NO REV.:
R
E
V
.:
P
A
R
T
N
O
table LZT 142 0001, category process equipment and is only entended as a guide.
CDP-T Small
CDP-T Small
8
Sheetmetal flatstate is based on Dantherm Air Handling A/S
All designs originated by Dantherm Air Handling A/S are the
property of said Company and will be protected by Patents.
This Drawing is furnished with the understanding that the
essence there of will not be reproduced in whole or in part
without written authorization by Dantherm Air Handling A/S.
Linear dimensions without tolerances according to
DS/EN 22768-1 medium. Angular dimensions without tolerances: ± 1°
V
431
59
Ø3/4”
700
294
307
80
W
89
73 80
426 36
Surface appearance according to reference
g
SCALE: NOT TO SCALE
3
5
1
5
1
6
351516
MATERIAL:
THICKNESS:
WEIGHT:
REV. BY:
DATE:
REF.:
DATE:
PART NO REV.:
R
E
V
.:
P
A
R
T
N
O
table LZT 142 0001, category process equipment and is only entended as a guide.
CDP-T Small
CDP-T Small
8
Sheetmetal flatstate is based on Dantherm Air Handling A/S
All designs originated by Dantherm Air Handling A/S are the
property of said Company and will be protected by Patents.
This Drawing is furnished with the understanding that the
essence there of will not be reproduced in whole or in part
without written authorization by Dantherm Air Handling A/S.
Linear dimensions without tolerances according to
DS/EN 22768-1 medium. Angular dimensions without tolerances: ± 1°
V
431
59
Ø3/4”
700
294
307
80
W
89
73 80
426 36