Dantherm CDP 70 Service Kit Instructions

5
EN
099241 • vers. 1.2 • 08.02.2019
11.
Mount the humidity sensor on the bracket with
PPI lter and two cable binders as shown.
Note: the white surface and hole in the sensor must be
facing front.
12.
Run a full test of the unit with the latest software version.
(Instructions on how to download and install latest software version is found on next page)
13.
Remount the front and make sure the sensor is
visible through the grille.
Instructions

Dantherm CDP 70 Specifications

General

Brand	Dantherm
Model	CDP 70
Category	Dehumidifier
Language	English