To Next PageTo Next PageWhy does my Dantherm CS030040B Air Conditioner have a Low Temperature Alarm (F=06)?
A Low Temperature Alarm (F=06) on your Dantherm Air Conditioner indicates that there is insufficient heat load or the unit is oversized for the application. Contact Dantherm, Inc.
Why is my Dantherm CS030040B condensate draining continuously?
Continuous condensate draining from your Dantherm Air Conditioner suggests that the enclosure is not properly sealed. Check and seal all openings to resolve this issue.
General| Brand | Dantherm |
|---|---|
| Model | CS030040B |
| Category | Air Conditioner |
| Language | English |
Explains the structure of the model numbers and their components.
Provides key performance specifications like BTU/Hr, voltage, and weight.
Illustrates the physical dimensions and layout of the air conditioner unit.
Provides the cutout and mounting hole dimensions for installing the unit.
Instructions for correctly installing the provided gaskets during unit mounting.
Covers electrical connections, mounting, and other essential installation procedures.
Steps to power on the unit and verify basic functionality after installation.
A schematic illustrating the components and connections of the USACG-6 controller.
Step-by-step instructions to adjust the desired heating temperature set point.
Step-by-step instructions to adjust the desired cooling temperature set point.
How to switch between Celsius and Fahrenheit for temperature readings.
Overview of diagnosing system issues and interpreting operational status.
Guidance on reading return temperature and identifying specific fault codes.
Procedure to run a diagnostic "TEST" sequence on the controller's functions.
Instructions to restore controller settings to their original factory configuration.
Outlines recommended maintenance tasks and their frequencies (monthly, yearly).
Instructions on how to clean the evaporator and condenser coils for optimal performance.
Information on the sealed compressor and refrigerant system maintenance.
Maintenance requirements for the evaporator and condenser blowers.
Guidance on checking and replacing the external air filters as needed.
Location and procedure for accessing and resetting the overload device.
A chart to help diagnose and resolve common problems with the unit.
A visual representation of the unit's electrical connections and components.
Specific wiring diagram for CS030040 models with 1200W or 1500W heaters.
An illustrated guide listing and identifying available spare parts for the unit.
