Dantherm Flexibox 460 - Changing Parameters

12
Display
Changing
parameters
Parameter Description Default
Heater
setpoint
The minimum acceptable shelter temperature. If
lower the external heat will be active if connected.
12
Cooling
setpoint
The maximum shelter temperature, at which the
unit will start freecooling, if outside temperature is
lower. If not the AC output will trigger
25
External AC Enable/disable external aircon OFF
Lead/Lag Not active
Mode
  
Idle Menu item up Select item Menu item down
menu item Step value up Store and return Step value down
28°C
CC4 Flexibox
29°C
Type
Cooling setpoint
Room temperature
Operation mode
Mode
Description
Free cooling
Active cooling
Heat
Alarm
28°C
CC4 Combo
29°C
28°C
CC4 Combo
29°C
28°C
CC4 Combo
29°C
Warning
Caution
CC4
Cool SetPt [24
Heater SetPt:10
Ext AirCon :1
Lead/Lag :1
CANCEL SAVE
CC4
Cool SetPt [24
Heater SetPt:10
Ext AirCon :1
Lead/Lag :1
CANCEL SAVE
Selection
cursor
1=Enabled
0=Disabled
Temp in C°
NOT USED
Menu active
cursor