10
29. Phone/line button
Use this button to configure both aux (26,28) inputs for either line level or phone level.
When the input level is too low, press the line/phone level switch. When the light is on, the level of the
input signal will be boosted. The phone level adjusts the input sensitivity into the correct level for MP3
players, smartphones or tablets. Now you can playback your MP3 devices directly without signal loss.
30. IEC power inlet
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, and then turn on the power (21) switch to operate
the unit.
31. Master trim output
This selector allows you, to trim the output level for the master A/B (44,45) outputs. Range -10 to +10dB.
32. Master A mono/stereo switch
Use this switch if you want to connect a mono amplifier to the master A (45) outputs.
33. Master A RCA unbalanced out connectors
Use these outputs to connect an amplifier with unbalanced inputs.
34. Monitor RCA unbalanced out connectors
Use these outputs to connect an amplifier with unbalanced inputs.
35. Record A RCA unbalanced out connector
Use these to connect a recording device.
36. Channel 5 RCA line input connectors
Use to connect a line level device. You can select either this line input or the aux group with the
corresponding input selection (15) switch on the frontpanel.
37. Channel 4 RCA line input connectors
Use to connect a line level device. You can select one of the two line inputs with the corresponding input
selection (14) switch on the frontpanel.
38. Channel 3 RCA line input connectors
Use to connect a line level device. You can select one of two the Line inputs with the corresponding
input selection (14) switch on the frontpanel.
39. Channel 2 RCA line input connectors
Use the RCA inputs to connect a line level device.
40. Channel 1 RCA line input connectors
Use the RCA inputs to connect a line level device.
To Next Page
Loading...
Need help?
General
