EasyManuals Logo

DAPAudio MMIX-4 User Manual

DAPAudio MMIX-4
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
7
Frontview
Fig. 2
1. Channel 1 level control
Use this control to adjust the level of channel 1.
2. Channel 2 level control
Use this control to adjust the level of channel 2.
3. Channel 3 level control
Use this control to adjust the level of channel 3.
4. Channel 4 level control
Use this control to adjust the level of channel 4.
5. Output L/R signal VU meter
This meter is a multi-step LED; respectively the green LEDs show -20, -5 and 0dB. red LEDs show +6 and +20
dB. The red LEDs should only blink occasionally during loud passages. If the red LEDs light up frequently
you have to lower the Level (1, 2, 3, 4) controls.
6. Channel 1 Combo input
Electronically balanced Combo-type input. Accept either XLR or Jack inputs. Due to the wide range of
the level (1) control this input can be used for microphone level up to line level devices.
7. Channel 2 Combo input
Electronically balanced Combo-type input. Accept either XLR or Jack inputs. Due to the wide range of
the level (2) control this input can be used for microphone level up to line level devices.
8. Channel 3 Combo input
Electronically balanced Combo-type input. Accept either XLR or Jack inputs. Due to the wide range of
the level (3) control this input can be used for microphone level up to line level devices.
9. Channel 4 Combo input
Electronically balanced Combo-type input. Accept either XLR or Jack inputs. Due to the wide range of
the level (4) control this input can be used for microphone level up to line level devices.
10. Power LED
Indicates that the unit is powered on.
11. Channel 1 pan control
By using the panorama control you can change the input signal’s position within the stereo image. When
the panorama control is set to center position, the audio signal is equal for both the left and right output.
12. Channel 2 pan control
By using the panorama control you can change the input signal’s position within the stereo image. When
the panorama control is set to center position, the audio signal is equal for both the left and right output.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DAPAudio MMIX-4 and is the answer not in the manual?

DAPAudio MMIX-4 Specifications

General IconGeneral
BrandDAPAudio
ModelMMIX-4
CategoryMusic Mixer
LanguageEnglish

Related product manuals