Need help?Do you have a question about the Darkglass Electronics Super Symmetry and is the answer not in the manual?
General| Type | Compressor |
|---|---|
| Power Supply | 9V DC (center negative) |
| Bypass | True Bypass |
| Input Impedance | 1 MΩ |
| Output Impedance | 1kΩ |
| Controls | Blend |
Use only a regulated 9V DC adapter with a center-negative plug. Unregulated supplies or higher voltages may cause damage.
Register your product at mypedal.darkglass.com using the serial number on the back of the pedal to activate the warranty.
For optimal noise performance, set the Input knob as high as possible while maintaining clean operation to minimize noise floor increase.
Mixes compressed and clean signals for compression adjustment, allowing unity gain without re-adjusting input/output levels.
Adjusts gain and threshold for compression. Higher settings increase compression levels and ensure clean operation.
Determines the amount of compression applied, also known as Peak Reduction.
Sets the overall output volume level of the unit.
Sets the time until gain reduction begins; higher settings result in faster attack times.
Sets the time after which the signal returns to pre gain-reduction levels; higher settings hold compression longer.
Specifications are subject to change without notice for continuous improvement. Contact for questions.
Fulfills requirements of EN55013, EN55020, EN60555-2, EN60555-3, RoHS, WEEE.
Address: HERNESAARENRANTA 3L 00150 HELSINKI - FINLAND. Tel: +358 401504121. Website: WWW.DARKGLASS.COM.
To Next Page
