37
LOCATION 463: PROGRAMMING THE CURRENT MINUTES - ONES DIGIT
Location 463 contains the current minutes - ones digit. The time is entered in 24 hour time. If the current time is 5:25 pm,
the 24 hour time is 17:25, so this location should contain a "5", which is the current minutes - ones digit. If the current time
is 9:36 am, the 24 hour time is 09:36 and this location should contain a "6".
LOCATIONS 464 - 475: PROGRAMMING WIRELESS ZONE EXPANDER
Locations 464-475 are referred to as “Shadow Location”. The DL250 wireless zone expander / receiver contains nonvolatile
memory for storing specific information about the receiver and each transmitter. Because of the amount of information and
the limited amount of programming locations available on the DL250, a set of Shadow Locations are employed to transfer
information from the DL250 to the wireless zone expander / receiver during programming. These shadow locations are
actual locations on the DL250, but are not used by the DL250. Instead, the DL250 wireless zone expander / receiver will
read these locations whenever a new set of programming parameter is ready to be set in the receiver. The DL250 wireless
zone expander / receiver manual must be referred to when these locations are used to program the wireless zone expander
/ receiver.
THE FOLLOWING LOCATIONS ARE ACCESSIBLE ONLY THROUGH DOWNLOADING
LOCATIONS 000-007: CONTROL PANEL ACCESS CODE
Locations 000-007 contain the eight digit access code the DL250 must receive from the downloading software before the
panel will permit downloading to occur. The factory default code is listed in the instructions provided with the DAS download
software package.
LOCATIONS 008-023: CALL BACK TELEPHONE NUMBER
If a telephone number is programmed into these locations, and "callback" is enabled in location 024, the control panel will
hang up for approximately 36 seconds (insuring that the calling party has disconnected), and then call back. If tone dialling
is desired, program an "F" in location 008. Four second delays can be obtained anywhere in the sequence by programming
a "D" in the appropriate delay location. WARNING: THE CALLBACK PHONE NUMBER SHOULD ALWAYS BE
REVIEWED FOR ACCURACY BEFORE DISCONNECTING.
LOCATION 024: CALL BACK OPTIONAL FEATURES
The number programmed in location 024 will set the callback options for the control panel. Any or all of the features below
can be obtained by programming the appropriate data in this location. The correct data can be obtained by ADDING the
values of the corresponding characteristics from the table below (possible values are 0 to 7).
VALUE CHARACTERISTIC
1 Panel will automatically callback for download session.
2 Site initiated download call by entering [¬][9][8][#] at Code Pad, and/or automatic callback
if a "1" is programmed in location 375.
4 Panel will automatically callback when the event log is full.
LOCATION 025: LOCAL PROGRAMMING LOCKOUT
Location 025 is used to disable local programming lockout. If a "5" is programmed in this location, all local programming is
locked out. Any other number in location 025 will allow all local programming.
LOCATION 026: CONTROL PANEL SHUTDOWN
Location 026 is used to shut down the control panel. Programming an "A" in this location will completely shutdown the control
panel. The Code Pad will appear "dead" and the siren and communicator will not operate. WARNING: EXTREME CARE
SHOULD BE TAKEN NOT TO INADVERTENTLY PROGRAM THIS LOCATION.
To Next Page
Loading...