12
LOCATIONS 135-139: SECONDARY ACCOUNT CODE
Locations 135-139 contain the account code for phone #2. The second account code can be programmed as per the
primary account code. This account code is reported when partition two is programmed or split or dual reporting is enabled.
If the account code is three digits long, use locations 135, 136, and 137. If a zero "0" is part of the account code it must be
programmed as a "10". Program a "0" to indicate the end of the account code. If these locations contain a "0", the account
code in locations 113-117 will be reported.
LOCATION 140: SECONDARY FORMAT
Location 140 contains the communicator format used to transmit to the receiver connected to phone #2. The second format
is used when split or dual reporting is required. Consult the instructions for your central station receiver to determine which
format is compatible. Select a format from the format chart. If you require a format other than those listed, review the
override options described in locations 252-255 to build the appropriate format. A "15" must be programmed in location
140 in addition to the entries into locations 252-255 in order to crate a special format. If this location contains a "0", the
format programmed into location 118 will be selected.
LOCATIONS 141-145: ACCOUNT CODE 3
Locations 141-145 are utilised to assign an account code for partition #3 if a unique code is desired. The third account code
can be programmed as per the primary account code . If these locations contain "0", the account code listed in locations
113-117 will be used.
LOCATIONS 146: COMMUNICATOR DIALLING SEQUENCE OPTIONS
The number programmed into this location determines the sequence and method the communicator will utilise when
reporting an event code. Use the table below to build the appropriate number. Add the number(s) associated with the
desired features and program the sum in this location. Factory default is "3 programming the characteristics for data 1 and
data 2 (1 + 2 = "3")
DATA DESCRIPTION
"1" Alternates between phone number #1 and phone number #2 in increments of two (2)calls to each, until the
selected number of dial attempts has been made to each number.
"2" The communicator attempts the number of dial attempts programmed into the number of dial attempts
location to phone number #1 and if unsuccessful, it will delay 5 minutes and attempt the same number of
dial attempts programmed into number of dial attempts to phone number #2. (see locations 095 and 096
dial attempts to phone number 1 & 2)
"4" Force the communicator to tie the account code to the phone number. If this feature is not selected the
account code will correspond to the partition. Select for split or dual reporting.
"8" The communicator attempts the number of dial attempts programmed into the number of dial attempts
location to phone number #1 and if unsuccessful, tries the same number of dial attempts programmed into
number of dial attempts to phone number #2. (see locations 095 and 096 dial attempts to phone numbers 1
& 2)
"0" If a "0" is entered, the account code corresponds to the partition.
SPLIT REPORTING:
Split reporting is when one group of zone or system events report to a selected destination via the primary phone number,
primary account code and primary format. A second group of zone or system events report to a separate destination via
the second phone number, the second account code and the second format.
DUAL REPORTING:
Dual reporting is when all zone or system events report to a selected destination via the primary phone number, primary
account code and primary format. The same events report to a separate destination via the second phone number, the
second account code and the second format.
NOTE: For most installations, default data "3" is required. Program a "4" for split or dual reporting.
To Next Page
Loading...