DAS DL-250 - Page 11

11
LOCATION 118: PRIMARY FORMAT
The primary format is transmitted when the primary phone number is dialled. Select a format from below, and program the
appropriate number in this location.
DATA FORMAT DESCRIPTION
0 LOCAL ONLY COMMUNICATOR IS DISABLED
1 ADEMCO CONTACT ID DTMF FORMAT
2 ADEMCO 4/2 EXPRESS DTMF FORMAT
3 PAGER FORMAT REPORTS IN 4 + 3 FORMAT AND/OR DOMESTIC DIALLING
4 ADEMCO HIGH SPEED DTMF FORMAT
5 RADIONICS EXTENDED SLOW 1800Hz TRANSMITTAL 2300Hz HANDSHAKE 20 PPS HEX EXT
DOUBLE ROUND
6 CADDX MODEM PROPRIETARY
7 RADIONICS EXTENDED FAST 1800Hz TRANSMITTAL 2300Hz HANDSHAKE 40 PPS HEX EXT
DOUBLE ROUND
8 RADIONICS EXTENDED FAST 1800Hz TRANSMITTAL 1400Hz HANDSHAKE 40 PPS HEX EXT
DOUBLE ROUND
9 RADIONICS EXT FAST
W/PARITY
1800Hz TRANSMITTAL 2300Hz HANDSHAKE 40 PPS HEX
EXTENDED
10 NOT USED
11 ADEMCO/SILENT KNIGHT
SLOW
1900Hz TRANSMITTAL 1400Hz HANDSHAKE 10 PPS DOUBLE
ROUND PARITY
12 SILENT KNIGHT 4+2 FAST 1900Hz TRANSMITTAL 1400Hz HANDSHAKE 20 PPS DOUBLE
ROUND PARITY
13 SESCOA/FRANKLIN FAST 1800Hz TRANSMITTAL 2300Hz HANDSHAKE 20 PPS HEX
DOUBLE ROUND
14 SIA FSK FORMAT
15 CUSTOM FORMAT SELECT YOUR OWN FORMAT FOR NON STANDARD BASE
STATIONS. REFER TO APPENDIX (3).
Location 118 contains the communicator format used to transmit to the receiver connected to the phone #1. Consult the
instructions for your central station receiver to determine which format is compatible. Select a format from the 14 listed
above. If you require a format other than those listed, review the override options described in locations 252-255, to build
the appropriate format. A "15" must be programmed in location 118 in addition to the entries into locations 252-255 in order
to create a special format. If this location contains a "0", the built-in communicator will be disabled, and the DL250 will
function as a local only control. When using pager format for domestic dialling, program the primary account code to "1717"
and program a "1" in location 192 (all abort enable). Your telephone number will also require at least four (4) pauses ("13"s)
added at the end of the phone number. Note The dial attempt counter must not be less than “4" attempts if the second
phone number is programmed.
LOCATIONS 119-134: SECONDARY PHONE NUMBER
Locations 119-134 contain phone #2. This number allows certain communicator reports to go to another number (split
reporting), or to cause the communicator to dial a second number if the primary number does not respond after the number
of attempts programmed into location 95 have been tried unsuccessfully, or for dual reporting. The same number of
attempts are made with the second phone number unless split or dual reporting is selected were the dial attempts in location
96 are used. Tone dialling and delay instructions are the same as for the primary number. A "14" indicates the end of the
phone number.