9
LOCATIONS 000-003: PROGRAMMING THE MASTER ARM/DISARM CODE
Locations 000-003 contain the master arm/disarm code (user number 1). Location 000 contains the first digit of the code;
location 003 contains the fourth digit of the code. THE CODE MUST CONTAIN FOUR (4) DIGITS. The master code can
then be used in the RUN mode to enter arm/disarm codes 1 - 15. The factory default code is [1][2][3][4].
LOCATIONS 004-055: PROGRAMMING THE ARM/DISARM CODE FOR USERS 2 THROUGH 14
Locations 004-055 contain the arm/disarm codes for users 2 through 14. To program these codes, follow the instructions
in the paragraph above. To disable these codes, program a "15" (factory default) as the first digit of the code. These codes
can be changed in the RUN mode using the master code (refer to operator's manual).
LOCATIONS 056-059: PROGRAMMING THE ARM/DISARM CODE FOR USER 15 (DURESS CODE)
Locations 056-059 contain the arm/disarm code for user number 15 (Duress Code). To program this code, follow the
instructions in the paragraph above. This code can be used as a duress code if so programmed in locations 288 - 291.
Factory default for this code is "15", disabled.
LOCATION 060-063: GO TO PROGRAM CODE
Locations 060-063 contain the "Go To Program" access code. Location 060 contains the first digit of the code and location
063 contains the fourth digit of the code. THE CODE MUST CONTAIN FOUR (4) DIGITS. With the DL250 disarmed, the
"Go To Program" access code can be used to enter the program mode. To disable the "Go To Program" access code,
program a "15" in location 060. The factory default setting is [9][7][1][3]. NOTE: The first digit of this code should not match
the Quick-Arm digit. NOTE: If a "15" is programmed into location 60 to disable this code, programming can only be
accessed through the downloading software , a plug in programmer or using the program code on a LCD code pad.
LOCATIONS 064-079: PARTITION SELECT FOR CODES 1-15 AND PROGRAM CODE
PARTITIONED SYSTEMS:
If partitions are utilised, codes may be assigned to a specific partition by using locations 064-079. This is done by disabling
each individual code (code 1 is location 064, code 15 is location 079) for each of the four partitions that code should not
have access to. Codes are selected by adding the binary equivalents for each partition together and placing that number
in the proper location. Partition One = 1, Partition Two = 2, and Partition Three = 4. For example, if code 2 should only be
valid for Partition Three, program a "4" in location 065. If code 10 is valid for Partitions Two, and Three, a "6" would be
programmed in location 073. Factory default is "7", code valid for all partitions.
VALUE PARTITION SELECTION VALUE PARTITION SELECTION
0 NO PARTITIONS ENABLED 4 ENABLES PARTITION 3
1 ENABLES PARTITION 1 5 ENABLES PARTITION 1 & 3
2 ENABLES PARTITION 2 6 ENABLES PARTITION 2 & 3
3 ENABLES PARTITION 1 & 2 7 ENABLES PARTITION 1, 2 & 3
To Next Page
Loading...