4 Vantec series User's Manual
Vantec Series | Safety precautions
• The exclamation point inside an equilateral triangle is intended
to alert the users to the presence of important operating
and maintenance (servicing) instructions in the literature
accompanying the product. Heed all warnings. Follow all
instructions. Keep these instructions.
• WARNING: This is a class A product. In a domestic environment this
product may cause radio interferences in which case the user may
be required to take adequate measures.
• Use this product only in E1, E2, E3 or E4 environments according to
EN55103-2.
• Do not remove mains connector ground, it is dangerous and illegal.
Class I device. The product must be connected to a mains socket
outlet with protective earth connection. Only use this equipment
with an appropriate mains cord for your country.
• The lightning and arrowhead symbol warns about the presence of
uninsulated dangerous voltage. To reduce the risk of electric shock,
do not remove the cover.
• Do not install near any heat sources such as radiators, heat
registers, stoves or other apparatus that produce heat. The
circulation of air through the heatsink must not be blocked.
• Do not expose this device to rain or moisture. Do not use this
apparatus near water (for example, swimming pools and fountains).
Do not place any objects containing liquids, such as bottles or
glasses, on the top of the unit. Do not splash liquids on the unit.
IP-20 equipment.
• This symbol on the product indicates that this product should not
be treated as household waste. Instead it shall be handed over to
the appicable collection point for the recycling of electrical and
electronic equipment.
• Working temperature ranges from 15ºC to 45ºC with a relative
humidity of 95%, with ±10% of the rated main voltage value
indicated on the rear label (according to IEC 60065). If the fuse
needs to be replaced, please pay attention to correct type and
ratings.
• The outer wiring connected to the device requires installation by an
instructed person or the use of a flexible cable already prepared.
• If the apparatus is connected permanently, the electrical system
of the building must incorporate a multipolar switch with a
separation of contact of at least 3mm in each pole.
• To disconnect the device, you should use the mains plug. Unplug
this apparatus during lightning storms, earthquakes or when
unused for long periods of time.
• Do not place loudspeakers in proximity to devices sensitive to
magnetic fields such as television monitors or data storage
magnetic material.
• For enclosures with tripod socket, the maximum safety height from
floor to bottom of enclosure when mounting on a TRD-2 tripod,
with legs spread 55cm from the central pole, is:
VANTEC-12
115 cm
VANTEC-15 105 cm
• The appliance should be flown only from the rigging points and by
qualified personnel. Do not suspend the box from the handles.
• No user serviceable parts inside. Refer all servicing to qualified
service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally or has been dropped.
• Clean only with a dry cloth. Do not use any solvent based cleaners.
55 cm
To Next Page
Loading...
