troubleshooting
∙ 17 ∙
ISSUE SOLUTION
When using my Mini Maker
Wafe, the Cover gets very hot.
Is this normal?
Yes, this is completely normal. When using
your Wafe Maker, always lift and lower
the Cover by the Cover Handle. To prevent
personal injury, DO NOT lift the Cover so that
your arm is over the Cooking Surface as it is
hot and may cause injury. Lift from the side.
After using my Mini Maker Wafe
a few times, food is starting
to stick to the surface. What is
happening?
There is probably a build-up of burnt food
residue on the Cooking Surface. This is
normal, especially when cooking with sugar.
Allow the appliance to cool fully, pour on a
little cooking oil and let sit for 5–10 minutes.
Scrub Surface with a sponge or soft bristled
brush to dislodge food. Use a damp, soapy
cloth to wipe down the Cooking Surface.
Rinse the cloth and wipe again. If food
remains, pour on cooking oil and let sit for a
few hours, then scrub and wipe clean.
The Indicator Light will not turn on
and the Cooking Surface is failing
to heat.
1. Ensure that the power cord is plugged
into the power outlet.
2. Check to make sure the power outlet is
operating correctly.
3. Determine if a power failure has occurred
in your home, apartment or building.
To Next Page
Loading...
Need help?
General
