8 • Air Cooled Condenser User Manual
Do not lift with a choke sling around the unit. Spreader bars are recommended for lifting multiple fan
units (See Figure 2). Under no circumstances should the coil headers or piping be used for lifting
the unit. Ideally, the unit should be kept in its shipping crate until it is ready to be set in place.
WARNING: Use care when moving. Improper handling could result in injury. Proper
care should be taken when uncrating the unit. The packaging has wrapping bands with
sharp edges that are under tension, crating has staples and splinters. Proper protective
equipment should be worn by qualied personnel.
Figure 2
1.8 Installation
NOTE: There is no intent on the part of Data Aire, Inc. to dene local codes or statutes
which may supersede common trade practices. The manufacturer assumes no respon-
sibility for their interpretation. Consult local building codes and the National Electrical
Code (NEC) for special installation requirements.
1.8.1 Installation Checklist
As a precaution, review the following checklist to ensure proper operation:
• Check for any damage
• Check all wiring connections
WARNING: When preparing the equipment, proper care should be taken when uncrat-
ing the unit. The packaging has wrapping bands with sharp edges that are under ten-
sion, crating has staples and splinters. Proper protective equipment should be worn by
qualied personnel.
● Remove the metal strapping bands
● Remove the wooden crating
● Remove the protective plastic covering
WARNING: Before removing from the packaging inspect the unit for any damage.
Report any damage to the carrier and le a damage claim.
To Next Page
Loading...
Need help?
General
