Programming
8PowerScan™ PBT9300
Programming
The reader is factory-configured with a set of standard
default features. Customize your reader through use of
the programming bar codes available in the PowerScan
PBT9300. Check the corresponding features section for
your interface, and also the Data Editing and Symbologies
chapters of the PRG.
Using Programming Bar Codes
This manual contains bar codes which allow you to recon-
figure your reader. Some programming bar code labels,
like the "Reset Default Settings" on page 9, require only
the scan of that single label to enact the change.
Other bar codes require the reader to be placed in Pro-
gramming Mode prior to scanning them. Scan an ENTER/
EXIT bar code once to enter Programming Mode; scan the
desired parameter settings; scan the ENTER/EXIT bar
code again to accept your changes, which exits Program-
ming Mode and returns the reader to normal operation.
Configure Other Settings
Additional programming bar codes are available in the
PRG to allow for customizing programming features. If
your installation requires different programming than the
standard factory default settings, refer to the PRG.
Do not incinerate, disassemble, short ter-
minals or expose to high temperature. Risk
of fire, explosion. Use specified charger
only. Risk of explosion if the battery is
replaced by an incorrect type. Dispose of
the batteries as required by the relevant
laws in force.
WARNING
To Next Page
Loading...
Need help?
General
