Datalogic PowerScan PM9300 Series User Manual

Operating Mode
Quick Reference Guide 11
Operating Mode
Scan Mode
The reader can be set to operate in one of several scan-
ning modes. See the PRG for more information and set-
tings for any of the options:
Trigger Single (Default) — When the trigger is partially
pulled, the aiming is turned on, when the trigger is com-
pletely pulled the scanner is activated.
Scanning mode remains active until one of the following
events occurs:
• a programmable duration
1
has elapsed
• a label has been read
• the trigger is released
Trigger Hold Multiple — When the trigger is pulled, scan-
ning starts and the product scans until the trigger is
released or “maximum scan on time”
1
has elapsed. Read-
ing a label does not disable scanning. Double Read Time-
out
1
prevents undesired multiple reads in this mode.
Trigger Pulse Multiple — When the trigger is pulled and
released, scanning is activated until programmable dura-
tion
1
has elapsed or the trigger has been pulled again to
transition to another state. Double Read Timeout
1
pre-
vents undesired multiple reads while in this mode.
Flashing — The laser flashes
1
on and off regardless of the
trigger status.
Always On — No trigger pull is required to read a bar code.
Scanning is continually on. If the trigger is pulled, the
reader acts as if it is in Trigger Single (Default) Mode. Dou-
ble Read Timeout
1
prevents undesired multiple reads
while in this mode.
1. See the Product Reference Guide (PRG) for more information

Datalogic PowerScan PM9300 Series Specifications

General

Brand	Datalogic
Model	PowerScan PM9300 Series
Category	Barcode Reader
Language	English