Datalogic PowerScan PM9500 series User Manual

Installing the Battery Pack
6 PowerScan™ PM9500
Charging the Batteries
Once the BC 90x0 is powered, you can charge the reader's
batteries. Place the PowerScan
™
M9500 into the BC 90x0
cradle. The Reader LED on the cradle/battery charger
turns red. The battery is completely charged when the
Reader LED on the cradle/battery charger turns green.
The battery can also be charged in the spare battery slot
(BC91xx models only) or using the Multi Battery Charger
accessory.
Changing the Batteries
1. Push the button at the bottom of the handle as
shown to release the battery.
2. Pull down to remove the battery.
Do not incinerate, disassemble, short termi-
nals or expose to high temperature at risk of
fire, explosion. Use specified charger only. Risk
of explosion if the battery is replaced by incor-
rect type. Dispose of batteries as required by
the relevant laws in force.
WARNING
Button
1
2

Datalogic PowerScan PM9500 series Specifications

General

Connectivity	Cordless
Sealing	IP65
Light Source	LED
Image Capture	Yes
Battery Type	Lithium-Ion
Weight	400 g / 14.1 oz
Radio Range	Up to 100 m / 328 ft
Radio Frequency	433 MHz
Drop Resistance	Withstands repeated drops from 2.0 m / 6.6 ft onto concrete
Supported Symbologies	1D, 2D, Postal
Interface	RS-232, USB, Keyboard Wedge
Operating Temperature	-20 to 50 °C / -4 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Humidity	5 to 95% non-condensing
Dimensions	212 x 110 x 74 mm / 8.3 x 4.3 x 2.9 in
Power Supply	External power adapter