Regulatory Information
Quick Reference Guide 27
ENGLISH
The following information is provided to comply with the
rules imposed by international authorities and refers to
the correct use of your terminal.
STANDARD LASER SAFETY REGULATIONS
This product conforms to the applicable requirements of
both CDRH 21 CFR 1040 and EN 60825-1 at the date of
manufacture.
For installation, use and maintenance, it is not necessary
to open the device.
The product utilizes a low-power laser diode. Although
staring directly at the laser beam momentarily causes no
known biological damage, avoid staring at the beam as
one would with any very strong light source, such as the
sun. Avoid that the laser beam hits the eye of an observer,
even through reflective surfaces such as mirrors, etc.
LUCE LASER
NON FISSARE
IL FASCIO
APPAREC-
CHIO LASER
DI CLASSE 2
MASSIMA
POTENZA
D'USCITA:
LUNGHEZZA
D'ONDA
EMESSA:
CONFORME A
EN 60825-1
(2007)
LASERSTRAH-
LUNG NICHT IN
DEN STRAHL
BLICKEN PRO-
DUKT DER
LASERKLASSE 2
MAXIMALE AUS-
GANGSLEISTUNG:
WELLENLÄGE:
ENTSPR. EN
60825-1 (2007)
RAYON LASER
EVITER DE
REGARDER LE
RAYON APPA-
REIL LASER DE
CLASSE 2
PUISSANCE DE
SORTIE:
LONGUEUR
D'ONDE EMISE:
CONFORME A
EN 60825-1
(2007)
RAYO LÁSER
NO MIRAR
FIJO EL RAYO
APARATO
LÁSER DE
CLASE 2 MÁX-
IMA POTEN-
CIA DE SALIDA:
LONGITUD DE
ONDA EMIT-
IDA:
CONFORME A
EN 60825-1
(2007)
WARNING
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in exposure to
hazardous visible laser light.
ID FE
To Next Page
Loading...
Need help?
General
