Operating Modes
QUICK REFERENCE GUIDE
19
a label does not disable scanning. Double Read Timeout
1
prevents undesired multiple reads while in this mode.
Always On — The illuminator is always ON and the reader
is always ready for code reading. Double Read Timeout
1
prevents undesired multiple reads.
Flashing — The reader illuminator flashes on and off
regardless of the trigger status. Code reading takes place
only during the Flash On
1
time. Double Read Timeout
1
prevents undesired multiple reads.
Stand Mode — The scanner looks for changes within its
field-of-view. The Aiming Pattern is always on to show the
optimum reading area. If a predefined amount of move-
ment is detected, the white illumination switches on.
Scanning continues until a label is read or “Scanning Active
Time” is reached.
Retained Trigger Hold Multiple — Same as Trigger Hold
Multiple but all decoded labels are transmitted when the
trigger is released. The labels can be sorted before trans-
mission.
★ Default value
SCAN MODE
ENTER/EXIT PROGRAMMING MODE
★ Scan Mode = Trigger Single
To Next Page
Loading...
