User Manual Rhino™ 10
2.
Connect the null modem cable on COM1 of the Host.
3. Configure ActiveSync to use COM1. The following settings should be applied in the ActiveSync Connection
Settings dialog box:
On Rhino™ 10
1. Make sure no other application is using the COM1 port. In particular, check if ScanWedge is running and if
so, open the dialog and Exit.
2. Navigate to \Windows and locate ActiveSyncLauncher.
3. Connect the serial cable to Com1 (the right most DB9)
4. Double tap ActiveSyncLauncher. A dialog box will appear, and show the status of the connection process.
16
To Next Page
Loading...
