Datamax I-Class Mark II Installation And Use Guide

4
F) Install the GPIO Card into the printer. First insert the “Port” end into the cut-out in the
rear of the printer. Then pivot the GPIO Card onto the two Standoffs.
G) Loosely install the two previously removed Jack Screws and the two 5.5mm Nuts.
Jack
Screws
5.5mm
Nuts
H) Tighten the two Jack Screws and the two 5.5mm Nuts. Proceed to “Configuring the
Hardware” on the next page.

Datamax I-Class Mark II Specifications

General

Power Supply	100-240 VAC, 50-60 Hz
Print Resolution	203 dpi
Print Width	4.09 inches
Memory	16 MB DRAM, 8 MB Flash
Connectivity	USB, Serial, Ethernet
Media Handling	Roll-fed
Media Width	1.0" – 4.65" (25.4 mm – 118 mm)
Media Thickness	0.0025" – 0.010" (0.0635 mm – 0.254 mm)
Ribbon Width	1.0" – 4.5" (25.4 mm – 114.3 mm)
Ribbon Length	1968 feet (600 meters)
Print Speed	up to 12 ips
Dimensions	12.7" H x 12.6" W x 18.6" D (322.6 mm H x 320 mm W x 472.4 mm D)