I-Class
Diagnostics (continued)
Menu Item Details
LOOPBACK Not Supported
PRINT SIGNAL INFO
Prints signal names, pin assignments, settings, and
current states for reference.
GPIO SIGNAL INFO
WED 11:04AM 24MAR2003
CARD ID#1
OUTPUT SIGNALS
END OF PRINT
PIN# 6
LOW PULSE
CURRENT LEVEL 1
RIBBON LOW
PIN# 5
ACTIVE LOW
CURRENT LEVEL 1
SERVICE REQUIRED
PIN# 4
ACTIVE LOW
CURRENT LEVEL 0
MEDIA OUT
PIN# 3
ACTIVE LOW
CURRENT LEVEL 1
RIBBON OUT
PIN# 2
ACTIVE LOW
CURRENT LEVEL 1
INPUT SIGNALS
START OF PRINT
PIN# 8
ACTIVE HIGH
CURRENT LEVEL 0
BACKUP LABEL
PIN# 7
DISABLED
CURRENT LEVEL 0
TEST SCANNER Tests the Linear Scanner, where:
ALIGNMENT TEST
Reads a bar code then displays the decoded data, the
code type and scan count, repeating.
SCAN TEST
Reads a bar code then displays the decoded data, the
code type and scan count, non-repeating.
TEST RFID Tests RFID, where:
TAG DATA Reads the data encoded on the RFID chip.
DEVICE VERSION Displays the type and version of the encoding device.
TAG ID – HF ONLY Reads and displays the High Frequency Tag ID number.
PRINT TEST RATE (min)
Allows a label-to-label delay (0 - 120 minutes) when
printing test label batches, where:
000 (0 - 120)
Is the selected delay interval, in minutes.
To Next Page
Loading...
