Dataprobe iBoot G2+ Manual&Nbsp;

V130108E iBoot-G2+ Page 13
AutoPing Enabled:
If the AutoPing feature is in use, the page will also
display the current status, OK or Failed, for each
AutoPing used, with a counter showing how many
times the Action was triggered. Reset buttons for
the Trigger counters are provided.
Heartbeat Enabled:
If the Heartbeat feature is enabled, the page will
display the current status, OK or Fail of the
Heartbeat, with a counter showing how many times
the Action was triggered. Reset buttons for the
Trigger counters are provided.
Navigation Buttons:
Refresh: Use the Refresh button to obtain the latest
status of iBoot. Using your browser's refresh button
can lead to inadvertent power switching. If an NTP
server is being used, the time of the last refresh will
be shown in the upper right corner.
Setup:
To access the Setup page, the administrator credentials are required. When logged in as User, the
challenge for Administrator credentials will be offered.
Logout:
When you are finished with iBoot, click on
Logout. A Goodbye page will be displayed. This page
has a URL link to re-connect with the iBoot. The
linkback URL is user settable. If no linkback is set, the
hyperlink will be the unit’s IP Address.

Dataprobe iBoot G2+ Specifications

General

Brand	Dataprobe
Model	iBoot G2+
Category	Switch
Language	English