Dataprobe iBoot G2+ User Manual

V110120E iBoot-G2+ Page 22
H
eartbeatPort9100

DxPPort:9100
DxPControl:Enabled
DxPQuery:Disabled
Timeout:2
set ipmode <static | dhcp> This command sets the IP Address setting mode. Static
mode locks the address as set, dhcp mode allows DHCP
server to assign address.
set ipaddress <dotted decimal> This command is used to set the iBoot-G2’s ip address. 192.168.1.254
set subnet <dotted decimal> This command is used to set the iBoot-G2’s subnet
mask.
255.255.255.0
set gateway <dotted decimal> This command is used to set the Gateway 192.168.1.1
set http port <0-65535> This command sets the port that the iBoot-G2’s web
server listens for incoming connections on. When set to
0 the web server is disabled.
80
set telnet port <0-65535> This command sets the port that the iBoot-G2’s Telnet
server listens for incoming connections on. When set to
0 the Telnet server is disabled
23
Set heartbeat port <0-65535> This command sets the port for the heartbeat protocol.
The heartbeat uses UDP and can be the same port
number as DxP, which is TCP
9100
set dxp port <0-65535> This command sets the port that the iBoot-G2’s DxP
protocol service listens for incoming connections on.
When set to 0 the Protocol service is disabled.
Note: At least one of the above MUST NOT be 0. The
CLI will protect against all 3 from being set to 0.
9100
set dxp control <enable/disable> This command allows the main and expansion ports to
be controlled using Dataprobe Exchange Protocol (DxP)
commands.
Disabled
set dxp query <enabled/disable> This command allows the status of the main and
expansion ports to be queried using DxP
Enabled
set timeout <0-999> This command sets the automatic network timeout in
minutes.
2
Autoping Commands
These commands require a reboot before they will take effect.
These commands are available to the administrator only.
get autoping This command returns all of the AutoPing settings as shown below.
Autoping1ABStatusTriggerCount
IPAddress:192.168.1.70.0.0.0OK0
Frequency:1010
FailCount:33
Logic:AAndB
Action:Cycle
Outlet:Main

Autoping2StatusTriggerCount
IPAddress:192.168.1.6OK0
Frequency:10
FailCount:3
Action:CycleOnce
Outlet:Exp1

Autoping3
StatusTriggerCount
IPAddress:192.168.1.2Fail43
Frequency:10
FailCount:1

Dataprobe iBoot G2+ Specifications

General

Brand	Dataprobe
Model	iBoot G2+
Category	Switch
Language	English