Datecs EP-2000 User Manual

Setup
16
5
DATECS
Е
P
-
2000
Memory Switches Setup
EP-2000 has 13 memory switches, which have the following action:
Flag OFF ON
1 Power ON/OFF sound disabled Power ON/OFF sound enabled
2 CR (ASCII code 13) is not executed CR is executed LF (ASCII code 10)
3 LF (ASCII code 10) is executed LF (ASCII code 10) is not executed
4 LF immediately after CR
as selected by flag 3
LF immediately after CR
is not executed
5 Default is Font A (12x24) Default is Font B (9x16)
6
Wide paper (78 mm) Thinner paper (58 mm)
7 Не се използва
8 Hardware flow control Xon/Xoff flow control
9 USB interface disabled USB interface enabled
10 USB is ALWAYS in DEVICE mode
11 Normal operation mode Protocol mode
12 Cutter enabled Cutter disabled
13 Default select printer Default select customer display
To change the settings:
1. Изключете принтера.
2. Switch ON the printer pressing FEED button.
POWER – green, ERROR – red, are rotated after every beep.
3. After the 4-th beep (after about 6 сек.) and 2 short beeps,
accompanied by 2 LED blinking – POWER – green, ERROR – red.
After releasing the FEED button in this printer state,
the printer enters the hardware setup mode (hardware menu)
and prints the current settings.
4
.
Follow the printer instruction
to make the necesary changes.
Care must be taken when
changing factory preset
configuration information.
Long pressing the FEED button (YES) – confirms changes.
Short pressing the FEED button (No Changes) – cancels changes.

Datecs EP-2000 Specifications

General

Brand	Datecs
Model	EP-2000
Category	Printer
Language	English