PRC-BC4-MS v
Safety Considerations
This product and manual must be thoroughly understood before
attempting installation and operation. To do so without proper
knowledge can result in equipment failure and bodily injury.
Caution: Before applying AC power, be sure that the
equipment has been properly configured for the
available line voltage. Attempted operation at
the wrong voltage can result in damage and
voids the warranty. See the manuals section on
installation. DO NOT operate equipment with
cover removed.
Earth Ground
All Datron products are supplied with a standard, 3-wire,
grounded AC plug. DO NOT attempt to disable the ground
terminal by using 2-wire adapters of any type. Any
disconnection of the equipment ground causes a potential
shock hazard that could result in personal injury. DO NOT
operate any equipment until a suitable ground has been
established. Consult the manual section on grounding.
Servicing
Only trained personnel should perform product repair. To avoid
electric shock, DO NOT open the case unless qualified to do so.
Various measurements and adjustments described in this
manual are performed with AC power applied and the protective
covers removed. Capacitors (particularly the large power supply
electrolytic type) can remain charged for a considerable time
after the unit has been shut off. Use particular care when
working around them, as a short circuit can release sufficient
energy to cause damage to the equipment and possible injury.
To protect against fire hazard, always replace line fuses with
ones of the same current rating and type (normal delay,
slow blow, etc.). DO NOT use higher value replacements in an
attempt to prevent fuse failure. If fuses are failing repeatedly this
indicates a probable defect in the equipment that needs
attention.
Use only genuine Datron factory parts for full performance and
safety of this product.
Made in the USA
To Next Page
Loading...