PRC-BC4-MS 2-1
Chapter 2: Installation
2.1 Unpacking
The PRC-BC4 is shipped in a heavy-duty corrugated cardboard carton. Do not
discard the cartons and packing materials in case the equipment needs to be
reshipped.
Inspect the PRC-BC4 for possible damage during shipment. Check all
accessories against the packing list. The packing list should include the
following items:
• PRC-BC4 multiple battery charger
•AC power cord
•DC power cord
• Four battery charging cables
• CY-2562 battery box
2.2 Power Configuration
2.2.1 AC Input Power
The PRC-BC4 can be configured for 110 or 220 VAC by opening the case and
changing the connections on the power transformer. A label on the case
indicates to what input voltage the transformer is set, however it is prudent to
visually inspect the power transformer to verify what input voltage it is
configured to accept (refer to Figure 2-2 on page 2-3).
CAUTION: Always remember to remove the AC power cable before
opening the PRC-BC4 case. If the charger is energized,
the technician is exposed to dangerous voltages that
can cause personal injury or death from electrical
shock.
To access the power transformer:
1. Make sure the PRC-BC4 is turned off and disconnected from any power
source (see CAUTION above).
To Next Page
Loading...