Datum Systems PSM-500 - Figure 3-2 A. Terminal Mode - Example of Unit Status Screen; Figure 3-2 B. Terminal Mode - Example of Unit Status Screen Selection

Operation PSM-500/500L/500LT SCPC Satellite Modem
Page 3-28 PSM-500/500L/500LT - Rev. 0.91
Figure 3-2a. Terminal Mode – Example of Unit Status Screen
Assuming that we wanted to view another of the Unit column screens. If we first press the “0” key
to indicate that we want to change to a “Unit” screen the following lower screen prompt will be
displayed:
Figure 3-2b. Terminal Mode – Example of Unit Status Screen Selection
PSM-500 VT100 Terminal Control
Unit Status
Modem Demod Tst Active
Reference Internal, Ok
C) Redundcy Internal 1:1
D) Unit ID
Model PSM-500
Serial# 13490
Version 0.10
Section ? 0)Unit, 1)Mod, 2)Demod, 3)Intf
Strike Number/Letter of Option to Select, TAB Key Aborts Selection.
PSM-500 VT100 Terminal Control
Unit Status
Modem Demod Tst Active
Reference Internal, Ok
C) Redundcy Internal 1:1
D) Unit ID
Model PSM-500
Serial# 13490
Version 0.10
Unit ? 0)Status, 1)Config, 2)Keybrd, 3)Remote, 4)USB, 5)Ref, 6)Redundcy,
7)Monitor, 8)Alarm, 9)Test
Strike Number/Letter of Option to Select, TAB Key Aborts Selection.