12
ROTARY LASER LEVEL
USING REMOTE
Your instrument comes with an infrared remote allows you to operate the laser at a distance up
to 20m. The remote is used to control the same functions as on the laser control panel except
on/o, tilt alarm and wind mode.
To operate your laser with the remote:
• Ensure the laser is turned on and self-levelled.
• The LED indicator ashes when the remote is sending a signal to the instrument.
• Follow the operation instructions in previous section.
OPERATION - LASER DETECTOR
Your detector uses 4 x AA 1.5V batteries. Locate battery compartment at the back of the
detector and insert batteries according to the symbols and polarity.
Mounting the sta clamp to the detector via the 1/4” thread on the back.
• Switch the detector on by pressing the power button.
• The LCD screen will display the battery level, accuracy setting and speaker mode.
• Press button (L) to change between dierent accuracy settings.
• Move the detector into the path of the laser beam.
• Hold the detector upright for horizontal beam or rotate the detector 90° for vertical beam.
• The direction arrows or level line on the LCD screen will indicate the position of the laser
beam. The detector will emit a constant beep once the level position has been located.
WARNING
If the product is used with accessories, for example masts, staves, poles, you
may increase the risk of being struck by lightning.
Do not operate the product in a thunderstorm.
!
To Next Page
Loading...
Need help?
General
