Davey AquaReviva DAR20C - Connecting the In-Line Electrolytic Cell to the Power Supply; Connecting the Flow Switch to the Power Supply

7
CONNECTING THE IN-LINE ELECTROLYTIC CELL TO THE POWER SUPPLY
The AquaReviva Salt Water Sanitiser uses a reverse polarity In-Line Electrolytic Cell for low maintenance
RSHUDWLRQ7KH$TXD5HYLYD3RZHU6XSSO\LV¿WWHGZLWKDÀH[LEOHOHDGWHUPLQDWHGZLWKSXVKRQEUDVV
connectors.
7KHVHPXVWEHFRUUHFWO\¿WWHGWRWKHFRQQHFWLRQVRQWKH&HOO)LWEODFNFRQQHFWRUVWRWKHRXWHUWLWDQLXPURGV
Fit the white connector to the middle titanium rod as per illustration below.
127(7KH$TXD5HYLYD&HOOLVVXSSOLHGZLWKDSDGGOHW\SHÀRZVZLWFK
which is to be installed on the Cell as shown in the diagram on page 6.
,03257$177KHÀRZVZLWFKPXVWEHPRXQWHGZLWKWKHKLJKOLJKWHGDUURZ
RQWRSRIWKHVZLWFKSRLQWLQJLQWKHGLUHFWLRQRIÀRZ
CONNECTING THE FLOW SWITCH TO THE POWER SUPPLY
-RLQWKHFRQQHFWRURQWKHÀRZVZLWFKDQGWKHFRQQHFWRURQWKHFHOOFDEOHWRJHWKHU7KH\ZLOOFOLSWRJHWKHU
CONNECTING THE FILTER CIRCULATION PUMP TO THE POWER SUPPLY
Insert the pool pump’s 3 pin plug into the 3 pin socket located on the back of the sanitiser’s power supply plug.
See diagram on following page.
NOTE: Filter Circulation Pump current draw should not exceed 8 Amps.
403165_AquaReviva_I&OI.indd 7 4/7/17 9:18 am