Davey AquaReviva DAR20C

9
EcoMineral SALT
For Mineral Salt applications please ensure the following quantity of EcoMineral Salt (P/N: EMSALT-15) and
EcoMineral Activator (P/N: EMACT-15) has been added to your pool.
CONVERTING EXISTING SALT POOLS NEW MINERAL SALT POOLS
Pool Size (Litres)
Davey Therapeutic
EcoMineral Salt
(15kg bags)
5,000 to 10,000 1 Bag = 15kg
10,001 to 20,000 2 Bags = 30kg
20,001 to 30,000 3 Bags = 45kg
30,001 to 40,000 4 Bags = 60kg
40,001 to 50,000 5 Bags = 75kg
50,001 to 60,000 6 Bags = 90kg
60,001 to 70,000 7 Bags = 105kg
70,001 to 80,000 8 Bags = 120kg
80,001 to 90,000 9 Bags = 135kg
90,001 to 100,000 10 Bags = 150kg
100,001 to 110,000 11 Bags = 165kg
110,001 to 120,000 12 Bags = 180kg
120,001 to 130,000 13 Bags = 195kg
130,001 to 140,000 14 Bags = 210kg
140,001 to 150,000 15 Bags = 225kg
1. &RQWLQXHWRRSHUDWH\RXU¿OWHUSXPS
for a period of 24 hours following the
addition of Davey EcoMineral Salt to
ensure proper blending has occurred.
2. Davey EcoMineral Salt can be used
with all Davey Salt Water Chlorinators
with recommended TDS levels of
between 4,000 and 6,000ppm.
3. When replacing normal pool salt with
Davey EcoMineral Salt, ensure that
TDS levels do not exceed 6,000ppm
after its addition to the pool.
4. Ensure pH levels are between 7.4 & 7.6
after the addition.
1. :LWKWKH¿OWHUSXPSUXQQLQJSRXUWKHFRQWHQWVRI'DYH\
EcoMineral Salt and Davey EcoMineral Activator into the
pool evenly around the edge.
2. &RQWLQXHWRRSHUDWHWKH¿OWHUSXPSIRUDSHULRGRI
24 hours following the addition to ensure proper blending
has occurred.
3. It is recommended that TDS levels be maintained between
4,000 and 6,000ppm.
4. When using the Davey EcoMineral Salt and Davey
EcoMineral Activator, ensure that TDS levels do not exceed
6,000ppm after its addition to the pool.
5. Ensure pH levels are between 7.4 & 7.6 after the addition.
Note: When the need arises to top up your pool with Davey EcoMineral Salt or Davey EcoMineral Activator, due to dilution through rainfall
or backwashing. Davey recommends you use equal quantities of EcoMineral Salt to Activator (ratio 1:1) and that you maintain your TDS
level between 4,000 and 6,000ppm. This will ensure your mineral pool water stays soft, silky and crystal clear.
After adding Davey EcoMineral Salts to your pool the water may temporarily have discolouration and form clusters of foam on the
surface. This is completely normal and is part of the mineralisation stage and transformation process. This may last for 24 hours,
KRZHYHUDIWHUWKLVWLPH\RXUSRROZLOOUHWXUQWRQRUPDODQGEHFRPHFU\VWDOFOHDUDQGFOHDQ,WLVUHFRPPHQGHGWKDW\RXUXQ\RXU¿OWHU
pump for a minimum 24 hours after the addition of Davey EcoMineral Salts.
Pool Size (Litres)
Davey Therapeutic
EcoMineral Salt
(15kg bags)
Davey EcoMineral
Activator
(15kg bags)
5,000 to 10,000 1 Bag = 15kg 2 Bags = 30kg
10,001 to 20,000 2 Bags = 30kg 5 Bags = 75kg
20,001 to 30,000 3 Bags = 45kg 7 Bags = 105kg
30,001 to 40,000 4 Bags = 60kg 9 Bags = 135kg
40,001 to 50,000 5 Bags = 75kg 12 Bags = 180kg
50,001 to 60,000 6 Bags = 90kg 14 Bags = 210kg
60,001 to 70,000 7 Bags = 105kg 16 Bags = 240kg
70,001 to 80,000 8 Bags = 120kg 19 Bags = 285kg
80,001 to 90,000 9 Bags = 135kg 21 Bags = 315kg
90,001 to 100,000 10 Bags = 150kg 23 Bags = 345kg
100,001 to 110,000 11 Bags = 165kg 26 Bags = 390kg
110,001 to 120,000 12 Bags = 180kg 28 Bags = 420kg
120,001 to 130,000 13 Bags = 195kg 30 Bags = 450kg
130,001 to 140,000 14 Bags = 210kg 33 Bags = 495kg
140,001 to 150,000 15 Bags = 225kg 35 Bags = 525kg
STORAGE AND SAFETY
1. Store in a dry, covered place away from direct sunlight for longer bag life
2. Always use the entire bag content of EcoMineral Salt, once opened. Do not keep open bags of EcoMineral Salt
as it is sensitive to moisture in the air.
3. Care should be taken to avoid contact with eyes and inhaling salt dust. Wearing eye protection and a dust mask is
good practice.
4. ,IH\HVEHFRPHDIIHFWHGÀXVKZLWKFOHDQWDSZDWHU
5. If skin becomes irritated, immediately wash contaminated skin with plenty of water and then wash with soap
and water.
• CHLORINE)RUDQHZSRROLQVWDOODWLRQWKDWKDVQRWEHHQFKORULQDWHGDGGVXI¿FLHQW&KORULQHOLTXLGRU
granular) to achieve a reading of 3 ppm (with a suitable test kit), or run the Sanitiser system continuously for at
least 24 hours or until a reading of 3 ppm is reached.
• STABILISER - It is essential that pool stabiliser be added and maintained at the rate of 30 - 50 ppm at all times.
Do not exceed 100 ppm. (FOR OUTDOOR POOLS ONLY)
• (Refer Day to Day Operation page 16 for further information).
403165_AquaReviva_I&OI.indd 9 4/7/17 9:18 am