EasyManuals Logo

Davey EcoSalt2 DES2-15E User Manual

Davey EcoSalt2 DES2-15E
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
PRE-START UP PROCEDURE
Before operating your EcoSalt2 salt pool chlorination system, please ensure the following quantity of pool
salt has been added to your pool.
POOL SALT:
To raise salt
concentration by
Salt required
ppm %
30,000L 40,000L 50,000L 60,000L 70,000L 80,000L 90,000L 100,000L
kg lbs kg lbs kg lbs kg lbs kg lbs kg lbs kg lbs kg lbs
1,000 0.1 30 66 40 88 50 110 60 132 70 154 80 176 90 198 100 220
2,000 0.2 60 132 80 176 100 220 120 265 140 309 160 353 180 397 200 441
3,000 0.3 90 198 120 265 150 331 180 397 210 463 240 529 270 595 300 661
4,000 0.4 120 265 160 353 200 441 240 529 280 617 320 705 360 794 400 882
5,000 0.5 150 331 200 441 250 551 300 661 350 772 400 882 450 992 500 1,102
6,000 0.6 180 397 240 529 300 661 360 794 420 926 480 1,058 540 1,190 600 1,323
• CHLORINE: For a new pool installation that has not been chlorinated, add sufficient Chlorine (liquid or
granular) to achieve a reading of 3 ppm (with a suitable test kit). Alternatively, run the EcoSalt2 salt pool
chlorination system continuously on BOOST MODE, for approximately 24 hours, or until a reading of 3 ppm
is reached.
• STABILISER: It is essential that pool stabiliser be added and maintained at the rate of 25 - 50 ppm at
all times (FOR OUTDOOR POOLS ONLY). For ORP controlled systems the stabiliser level should be
maintained between 15-25ppm.
(Refer Day to Day Operation page 27 for further information).
OPERATION OF YOUR EcoSalt2
CHLORINE OUTPUT is expressed as a percentage. Set the EcoSalt2 to the percentage output required
and the unit will automatically adjust the cell output to the set level. The EcoSalt2 is fitted with an electronic
control and warning system. This regulates the output of the EcoSalt2 to the pre-set maximum and changes
cell polarity as indicated by the + or – on the digital display. The polarity will alternate over a number of
hours of chlorination time, not necessarily pump-run hours. The warning system consists of one Operation
LED which will glow Green to indicate normal operation, or RED to indicate user attention required, see
troubleshooting on page 21.
8
ENGLISH

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Davey EcoSalt2 DES2-15E and is the answer not in the manual?

Davey EcoSalt2 DES2-15E Specifications

General IconGeneral
BrandDavey
ModelEcoSalt2 DES2-15E
CategorySwimming Pool Filter
LanguageEnglish

Related product manuals