7
Pipe Connection
Barrel unions are provided for connecting to the piping from the pool. The
pumps are designed to accept 40mm/50mm PVC fittings.
When plumbing the discharge pipe, ensure that the pipework does not
interfere with the pumps speed dial.
The use of any pipe smaller than those specified above is not recommended.
Suction piping should be free from all air leaks and any humps and hollows
which cause suction difficulties.
The discharge piping from the pump outlet should be connected to the inlet
connection on the swimming pool filter (usually at the filter control valve).
Barrel unions need to be hand tightened. No sealant, glues or silicones
are required.
Prior to using this pump you must ensure that: Checklist
• Speed Setting chosen is a compatible setting with other pool equipment
• The pump is installed in a safe and dry environment
• The pump enclosure has adequate drainage in the event of leakage
• Any transport plugs are removed
• The pipe-work is correctly sealed and supported
• The pump is primed correctly
• The power supply is correctly connected
• All steps have been taken for safe operation
• The filter has been plumbed with 40/50mm pipe
To Next Page
Loading...
Need help?
General
