32
• Before installing your RainBank
controller, please read all instructions
carefully as failures caused by
incorrect installation or operation
are not covered by the guarantee.
Your RainBank controller is designed
to handle clean water. The system
should not be used for any other
purpose without specific referral
to Davey. The use of the system to
pump flammable, corrosive and other
materials of a hazardous nature is
specifically excluded.
• WARNING: Water freezing inside
the RainBank will damage the unit.
Locate your RainBank and pump
so that they are not susceptible
to freezing.
• RainBank must be installed and
serviced by a licensed plumber.
• Check with your local water authority on
water restrictions when your rainwater
tank is connected to mains water.
• Do not enter a empty rainwater tank
– they may contain hazardous gases.
• Secure all openings to the rainwater
tank to ensure it will not permit
access to children.
!
Installation Inside Buildings: To
cater for possible plumbing leaks or damage
to the RainBank system components, the
installation must include an enclosure that
will capture any water spraying from the
plumbing or RainBank system and direct it
into a properly constructed drain tray.
!
Note: When installing a RainBank and/
or associated pump system inside a building,
allowance for possible high pressure leakage
MUST be made.
!
Note: In order to carry out routine
maintenance to the RainBank MUST be easily
accessible to the end user or home owner.
!
Note: If the supply cord is damaged, it
must be replaced by manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
WARNINGS
To Next Page
Loading...
Need help?
General
