TO TOILETS
AND/OR
LAUNDRY
(do not mix/cross-connect
with mains water supply)
* Pressure Limiting Valve
MAINS
WATER SUPPLY
3/4" BSP M
Incoming power
to RainBank
®
via 3 pin plug
3/4" BSP M
Stop valve
200 Micron ‘Y’ Strainer
recommended but not
supplied.
WHERE MAINS PRESSURE EXCEEDS 900kPa.
A PLV* MUST BE FITTED TO INLET!
RainBank
®
MUST BE INSTALLED
HORIZONTALLY AS ILLUSTRATED.
Stop valve
20mm hole
24 13
Step 3
plumbing ensuring that the lowest point
above the base of the tank.
Step 4
®
. For greater
distances between your rainwater tank
added between the pump and the rainwater
protective cinduit.
of the lowest point in the inlet pipe so the
pump will always be shut off well before it
can run dry or draw in air.
lowest cable tie.
®
Step 5
®
for easy
fitting to the plumbing.
Step 6
®
to the
pump.
Step 7
®
to the
plumbing.
Step 8
Step 9
WARNING: DO NOT FIT CHECK VALVES BETWEEN RAINBANK
®
, PUMP
AND TANK, UNLESS PUMP IS ABOVE MAXIMUM WATER LEVEL OF TANK.
IMPORTANT: ALL PIPEWORK AND OUTLET FITTINGS FROM RAINBANK
®
MUST BE LA-
BELLED TO AS3500. TANK MUST HAVE ISOLATION VALVE FITTED. DO NOT CONNECT WITH
CRIMPED FITTINGS.
100
100
To Next Page
Loading...
