9
4
Mains water supply
900kPa Maximum
1
3/4” BSP Male thread
2
3/4” BSP Male thread
3
Pump Power lead
4
RainBank
®
Power lead
5
Stop valve
Warning:
Do not reconnect with
mains water supply
Important:
All pipework and outlet
fittings from RainBank
®
must
be labelled to AS/NZS 3500
6
Float switch
7
Manual start button
8
Rainwater supply via pump
9
8
8
32 5
®
controller, please read all instructions
carefully as failures caused by
incorrect installation or operation are
®
controller is designed
should not be used for any other
purpose without specific referral to
®
will damage the unit.
®
and pump
so that they are not susceptible to
®
must be installed and
serviced by a licensed plumber.
on water restrictions when your
rainwater tank is connected to mains
water.
tank to ensure it will not permit access
to children.
Installation Inside Buildings
cater for possible plumbing leaks or damage
®
system components, the
installation must include an enclosure that will
capture any water spraying from the plumbing
®
system and direct it into a
properly constructed drain tray.
Note
®
and/or associated pump system inside a
building, allowance for possible high pressure
Note
®
accessible to the end user or home owner.
Note
must be replaced by manufacturer, its service
agent or similarly qualified persons in order to
To Next Page
Loading...
Need help?
General
