Davey RVM Series User Manual

Installation and
Operating Instructions for
RVM Pump Sets
Please pass these instructions on to the operator of this equipment.
WARNING: Failure to follow these instructions and comply with all applicable
codes may cause serious bodily injury and/or property damage.
NOTE: Prior to installation remove the inlet and outlet pipe
transport plugs & associated seals from the suction and/or
discharge ports.
WARNING : The RVM system and associated pipework operate under pressure.
Under no circumstances should the RVM System or associated pipework be
disassembled unless the internal pressure of the unit has been relieved. Failure to
observe this warning will expose persons to the possibility of personal injury and
may also result in damage to the pump, pipework or other property.

Davey RVM Series Specifications

General

Brand	Davey
Model	RVM Series
Category	Water Pump
Language	English

Summary

RVM Pump System Overview

RVM Water Pressure System

Details the basic configuration of the RVM water pressure system.

RVM Water Pressure System with Loss-Of-Prime Control Box

Describes the RVM system incorporating a loss-of-prime control box.

RVM Remote Start System with Loss-Of-Prime Control Box

Outlines the RVM system with remote start and loss-of-prime control features.

Installation and Setup Procedures

Pressure Switch Adjustments

Guidance on adjusting cut-in and cut-out settings for specific pressure switches.

Tank Precharge

Information on the recommended air pressure for the pressure tank.

Choosing a Site

Guidelines for selecting an appropriate installation location for the pump set.

Power Connection

Instructions for safely connecting the pump set to electrical power supply.

Electrical Power Surge Protection

Details on protecting the unit from potential electrical power surges.

Pipe Connections

Best practices for connecting inlet and outlet pipework for optimal performance.

Check Valves and Foot Valves

Guidance on fitting check and foot valves for different suction types.

Mains Water Supply Connection

Regulations and recommendations for connecting to mains water supply.

Priming and Operation

Step-by-step guide for priming and initial operation of the pump set.

Maintenance and Settings

General Maintenance

Routine checks required for the pump set, focusing on the pressure tank.

Pressure Settings Guide

Standard pressure settings for various pump models and their tanks.

Pump Controller Operation

Pressure Start Controller (R100P)

Operation details for the R100P pressure start controller, including indicators.

Remote Start Controller (R100R)

Operation details for the R100R remote start controller, including indicators.

Manual/Automatic Start Controller (R100 MA)

Operation details for the R100 MA controller, including indicators.

Control Box Wiring Diagrams

Pressure Start Controller 240V

Wiring diagram for the 240V Pressure Start control box.

Pressure Start Controller 415V

Wiring diagram for the 415V Pressure Start control box.

Remote Start Controller 240V

Wiring diagram for the 240V Remote Start control box.

Remote Start Controller 415V

Wiring diagram for the 415V Remote Start control box.

Manual/Automatic Start Controller 240V

Wiring diagram for the 240V Manual/Automatic Start control box.

Manual/Automatic Start Controller 415V

Wiring diagram for the 415V Manual/Automatic Start control box.

Trouble Shooting Check List

Pump Not Pumping

Common causes and solutions when the motor runs but no water is pumped.

Frequent Cycling

Troubleshooting for pumps that switch on and off too frequently.

Motor Not Starting

Diagnosing reasons why the motor does not start when switched on.

Davey Repair or Replacement Guarantee

Warranty Terms and Conditions

Details of the product warranty, exclusions, and claim procedures.