Davey DynaDrive DD60-10

Constant Pressure System
Installation and Operating
Instructions
ATTENTION: Please refer to www.bit.ly/dynadrive
for any product information updates, or simply
scan this QR code.
These can also be found on the product nameplate.
Please pass these instructions on to the operator of this equipment.
READ AND SAVE THESE INSTRUCTIONS.
Dyna
Drive
™
Models:
DD60-10(CE)
DD60-10NPT
DD90-11(CE) DD90-11NPT

Davey DynaDrive DD60-10 Specifications

General

Model	DD60-10
Category	Water Pump
Maximum Head	10 m
Housing Material	Stainless Steel
Seal Type	Mechanical Seal
Protection Rating	IP55
Outlet Size	1 inch
Power Supply	240 V AC
Maximum Flow Rate	100 L/min

Summary

Applications

Above ground water sources (flooded suction)

In-ground water sources (eg suction lift from in ground tank)

Spear point installations

Connecting mains scheme or town water supply to either suction, or discharge of pumps and pressure systems

Installs with a mains pressure hot water system

Installation

Choosing a site

Guidance on selecting a clean, dry site with a firm base near the water source.

Pipe connections

Emphasizes airtight seals, thread tape, and pipe support for optimal performance.

DynaDrive with air handling capacity

Details the pump's self-priming and air handling features, focusing on airtight suction lines.

Power connection

Advises on avoiding long extension leads and ensuring proper grounding for electrical connections.

The pressure tank

Specifies air pressure for the tank should be 70% of the set pressure.

Operation

Start-up procedure

Guides through the initial power-on sequence and LED indications.

Manual override

Explains how to switch the pump to manual override mode and its implications.

Main menu display

Describes how to navigate and view system information on the display.

Changing the set pressure

Details the procedure for adjusting the system's set pressure point.

Decommissioning the DynaDrive

Advanced Settings

Changing cut-in pressure point

Using a switch to override DynaDrive operation

Daisy-chain multiple DynaDrive systems

Technical Specifications

Operating limits

Hydraulic performance

Electrical data

Maintenance

Periodic pressure tank checks

Troubleshooting