6
Removal of the Pump from Pipework
Should it be necessary to remove the pump, follow these instructions:
1. Switch off the power and remove the plug from the power source.
NOTE: If the pump is wired into a time clock or another automatic control,
the wiring should be removed by a qualied electrician.
2. Close the water valves on the pool return and the pump inlet pipework.
3. Remove the discharge & suction barrel unions taking care not to lose the o-rings.
4. Move the pipework with the barrel unions attached until the pump can be pulled clear.
NOTE: When making any enquiries about your Silensor
be certain to quote
the model number from the nameplate located on motor.
Water Quality
Maintaining balanced water chemistry is important to the life of your pool pump. This pump is
designed to be used with pool and spa water, balanced in accordance with Langlier Saturation
Index, with a pH level of between 7.2 and 7.8 and is regularly treated with a chlorine sanitising
agent with the level not exceeding 3000ppm. Salt levels should be maintained between
4000ppm - 6000ppm.
Please consult your local pool shop regularly to have your water tested.
To Next Page
Loading...
Need help?
General
