2
Prior to using this pump you must ensure that:
• The pump is installed in a safe and dry environment
• The pump enclosure has adequate drainage in the event of leakage
• Any transport plugs are removed
• The pipe-work is correctly sealed and supported
• The pump is primed correctly
• The power supply is correctly connected
• All steps have been taken for safe operation
Appropriate details for all of these items are contained in the following Installation and
Operating Instructions. Read these in their entirety before switching on this pump. If you are
uncertain as to any of these Installation and Operating Instructions please contact your Davey
dealer or the appropriate Davey ofce as listed on the back of this document.
Your Davey Silensor
Congratulations on your purchase of a quality product from the Davey range of Pool and Spa
Equipment. You are assured of many years of reliable and efcient performance from your
Davey Silensor
backed by Davey’s three year guarantee.
Davey Silensors
have been designed to circulate swimming pool and spa water in conditions
set out in the Australian Standard for swimming pool water quality (AS 3633) or equivalent.
They should not be used for any other purpose without rst consulting your Davey Dealer or
the Davey Support Centre.
Davey design and build its own electric motors especially for its pumps. The matched motor
and “pumping end” are designed to provide the quietest operation while delivering maximum
water ow.
Davey’s innovative water cooled motor incorporates manual overload protection with a built-in
automatic thermostat designed to protect the motor from overheating. This protection will also
prevent ‘dry run’ damage.
Every Davey Silensor
is thoroughly tested against a number of pressure, voltage, current and
mechanical performance parameters. Davey’s advanced pump manufacturing technology
provides reliable and efcient pumping performance that lasts and lasts.
Location
The pump should be located as close to the water as practicable and mounted on a rm base
in a well drained position, high enough to prevent any ooding. It is the installer’s/owners
responsibility to locate the pump such that the nameplate can be easily read and it can readily
accessed for service.
Weather Protection
It is recommended that the pump is protected from the weather.
To Next Page
Loading...
Need help?
General
