To Next PageTo Next Page
Need help?Do you have a question about the Davey ProMaster PM200BT and is the answer not in the manual?
General| Frequency | 50 Hz |
|---|---|
| Model | PM200BT |
| Suction Port | 2 inches |
| Discharge Port | 2 inches |
| Inlet/Outlet Size | 2 inches |
Explains the advantages of VSD pumps in terms of lower noise, operating costs, and emissions.
Discusses common observations with variable speed pumps, like lower pressure and noise.
Highlights the need to check equipment compatibility with low flow settings.
Details voltage, frequency, plug, and the pump's built-in motor overload detection.
Lists national standards, emphasizes qualified electricians, and covers RCD requirements.
Provides guidance on pump run times for filtration, referencing Australian Standards.
Presents data on head, RPM, power input, insulation, voltage, and frequency.
Includes a diagram and table for pump dimensions and fitting sizes.
Specifies requirements for the pump's placement, ensuring accessibility and protection from flooding.
Advises protecting the pump from weather and ensuring enclosure ventilation.
Provides a diagram for correct pump wiring installation.
Covers barrel unions, pipe sizes, suction, and discharge piping requirements.
Lists optimal speed settings for filtration, cleaning, heating, and other pool functions.
Explains the flow rate requirements for Davey salt water chlorinators.
Details the LED system for identifying settings, programming, and warnings.
Describes the water-cooled design for smooth, quiet operation and heat transfer benefits.
Explains the feature for PM400BT to overcome friction losses and save energy.
Covers the RJ45 port for external control, connection, and diagnostics on PM400BT.
Explains the technology that cycles pump speed during backwash for effective cleaning.
Instructions for obtaining and installing the Davey Pool Pump mobile application.
Step-by-step guide for establishing a Bluetooth connection between the device and the pump.
Explains how to operate the pump manually or set up automated schedules via the app.
Describes how to configure the app for pumps controlled by external timers or chlorinators.
Guides users on setting up recurring pump operation times and speeds.
Details how to adjust priming speed and set the maximum operating speed.
Explains backwash configurations, the disconnect function, and factory reset.
Lists potential pump errors, their descriptions, and recommended actions for resolution.
Explains the RJ45 port for external control and provides pinout diagrams for connections.
Details how to use digital inputs to control pump speed from external control systems.
Explains how to use a 0-10V signal for analogue speed control, overriding dial settings.
Provides instructions for optimal operation of suction pool cleaners with the pump.
Step-by-step instructions for inspecting and cleaning the pump's strainer basket.
Addresses common causes of low or no water flow and how to resolve them.
Identifies potential reasons for the pump not operating and their solutions.
Provides instructions for safely disconnecting and removing the pump from the plumbing system.
Emphasizes the importance of pool water balance for pump longevity.
Consolidates warnings on power connections, suction hazards, and chemical handling.
Outlines the conditions, coverage, and exclusions of the product warranty.
