3
SolarMatic
TM
Installation Instructions-
Mounting the Control Unit
1. Please ensure the SolarMatic is mounted a minimum of 3 metres away
from the pool water and 1.5 metres above ground level.
2. Cut out mounting template on page 12 for location of drilling points.
(If the unit is to be mounted to a brick or concrete wall use a 7mm
masonry drill bit). Some walls such as limestone or cement render can
damage aluminium, if in doubt seal the wall before mounting the control
unit.Drillpilotholesandtscrewsprovided.
3. Mount unit via top moulding of the SolarMatic
TM
unit. Slot in bottom
panel can be used to ensure vertical location and stop accidental
movement of unit.
4. Plug 3 Pin Power Plug from control unit into a suitable weatherproof
10Amppoweroutlet.EnsureanappropriateRCDsafetydeviceistted
to mains power.
5. Plug solar pump into power outlet of the SolarMatic
TM
located at the
base of the unit.
IMPORTANT: 240VOLT MAINS POWER CONNECTION ONLY!
To Next Page
Loading...
Need help?
General
