DAVID F3300C.DV2 - Replace the Headlight Bulb

12
Replace the Headlight Bulb
WARNING: To reduce the risk of electric
shock and injury from moving parts,
unplug vacuum before cleaning or
servicing.
1. First remove the nozzle housing. Turn
the unit over to expose the underside.
Locate the two main nozzle screws
(Fig.1) and remove both. Turn the unit
right side up. Locate the two nozzle
tabs on the back of the unit (Fig. 2) and
unlatch the nozzle housing. (Note: It is
easier to remove the nozzle when the
vacuum is lying flat on its back.) Lift the
nozzle housing off the unit to expose the
light bulb.
2. Remove bulb by pulling it straight out of
the light socket (Fig. 3).
3. To install new bulb, simply reinsert the
bulb into the light socket.
4. Place nozzle housing back onto unit
with the front side of the nozzle set into
place first (Fig. 4) then press the nozzle
downward until nozzle “clicks” into
place on both sides. Turn unit over and
reinsert two main nozzle screws.
MAINTENANCE AND CARE
Fig. 1
Fig. 2
Fig. 3
Fig. 4