6
ASSEMBLING THE VACUUM
Positioning the Power Cord
• Loosen, but do not remove, the screw
holding the upper cord hook (Fig. 1).
• Position the cord between the cord
hook and the vacuum tube (Fig. 2).
Re-tighten the screw.
• Once the cord is secured by the cord hook,
proceed with wrapping the cord.
• Wrap the cord clockwise around the
top and bottom cord hooks. Fasten
the plug to the wrapped cord using the
channel on the plug. When not in use,
store the vacuum indoors in a clean,
dry area where it cannot be damaged
or cause injury.
Fig. 1
Fig. 2
To Next Page
Loading...
