Davis Instruments Anemometer Transmitter Kit User Manual

Product # 6330
A
NEMOMETER
T
RANSMITTER
K
IT
I
NSTALLATION
M
ANUAL
This manual describes how to install the Anemometer Transmitter Kit for Wire-
less Vantage Pro
TM
. The kit enables you to connect the anemometer from your
Integrated Sensor Suite (ISS) to its own transmitter, so it can be located away
from the ISS and communicate directly with your console/receiver.
C OMPONENTS
The Anemometer Transmitter Kit includes the following components and
mounting hardware:
1/4" Flat Washers
1/4" Lock Washers
1/4" Hex Nuts
3-Volt
Lithium
Battery
U-Bolts
1/4" x 1-1/2" Lag Screws
8" Cable Ties
4" Cable Tie
Transmitter Shelter

Davis Instruments Anemometer Transmitter Kit Specifications

General

Brand	Davis Instruments
Model	Anemometer Transmitter Kit
Category	Transmitter
Language	English

Summary

Components Overview

Tools and Setup

Removing the Anemometer from Current Location

Disconnecting Anemometer from ISS Transmitter

Steps to disconnect the anemometer from the ISS transmitter by removing radiation shield plates.

Reassembling Radiation Shield

Procedure for reassembling the radiation shield plates after disconnecting the anemometer.

Preparing the Anemometer Transmitter

Setting the Transmitter ID

Setting Console Receiver to Same ID

Viewing Current Wind Data

Steps to view wind direction and speed on the console after setup.

Troubleshooting No Current Wind Readings

Test Mode for Signal Issues

How to activate TEST mode on the transmitter to troubleshoot signal issues.

Choosing a Location for the Anemometer Transmitter

Range of Wireless Transmission

Factors affecting wireless transmission range and potential interference.

Mounting the Anemometer Transmitter

Mounting Anemometer on a Pole

Instructions for mounting the anemometer onto a pole using U-bolts.

Mounting Anemometer on a Vertical Surface

Mounting Transmitter Shelter on a Pole

Mounting Transmitter Shelter on a Vertical Surface

Troubleshooting Common Issues

Contacting Davis Instruments

Specifications

FCC Part 15 Class B Registration Warning

Regulatory warning regarding FCC Part 15 compliance for digital devices.