Console Location
7
Table & Shelf Placement
The console kickstand can be set to three different angles allowing five differ-
ent display angles.
1. Install the two round rubber feet on the bottom of the console. The rubber
feet help prevent damage to furniture and surfaces.
2. Lean the kickstand out by pulling on its top
edge.
You’ll see the indentation for your finger at
the top edge of the console.
3. Slide the catch to rest the kickstand in the
appropriate angle.
Choose low angles for display on a coffee
table or other low area. Choose higher
angles for display on a desk or shelf.
4. Install the two rubber channel feet on the
kickstand.
If necessary, pull up on the stand to close it. It will be a little tight, so it’s okay
to push hard enough to get it to slide.
To Next Page
Loading...
Need help?
General
