Alarm Mode
30
sound if the rate of change (in either direction) exceeds the threshold you set.
This alarm is updated every 15 minutes.
Time
The time alarm is a standard “alarm clock” alarm. It sounds for one minute at
the set time. Make sure you choose AM or PM, if you’re in 12-hour mode.
UV Dose
The UV dose alarm sounds when the accumulated UV dose has exceeded the
dose you set. The UV dose alarm does not arm unless the initial UV dose for
the day has been reset. Once the UV dose alarm value is set, clear the accumu-
lated UV dose. See “Clearing Weather Variables” on page 27.
Setting Alarms
1. Press ALARM to enter the Alarm Mode to view or set the high alarm
thresholds. The screen displays the current high alarm thresholds. The
ALARM and HIGHS icons also appear.
2. Press the right and left arrows to select one of the variables displayed on the
screen or use the console keys to select any weather variable. Also, press
HI/LOW to display the toggle between the high and low alarm threshold
settings.
3. Press 2ND then press ALARM to activate the currently selected weather
variable.
4. Press the right and left arrows to select digits in the threshold value.
5. Press the up and down arrows to change the digit’s value up and down.
6. Press DONE to finish changing the alarm setting.
7. Repeat steps 3 through 6 to change additional alarm settings.
8. Press DONE to exit Alarm Mode.
Setting the Time Alarm
1. Press ALARM to enter alarm mode.
The ALARM and HIGHS icons appear.
2. Press 2ND, then press TIME, then press 2ND again, and then press
ALARM.
The time field begins blinking.
3. Press the left and right arrows to select hours, minutes, or AM/PM.
4. Press up and down arrows to change the digit’s value up and down.
5. Press DONE to exit Alarm Mode.
Clearing Alarm Settings
1. Press ALARM to enter alarm mode.
The ALARM and HIGHS icons appear.
To Next Page
Loading...
Need help?
General
