DAVIS Vantage Pro2 - Running the Software; Macintosh Computer Installation; Adding a Station; About the Walkthrough

SETUP TEMP
To enter setup mode: Press and hold DONE and then press ( − ). Press
DONE to advance or BAR to step back through the setup messages:
1. RECEIVING FROM. Displays available transmitting stations.
2. ON/OFF. To set reception for one of the available transmitting stations.
3. RETRANSMIT ON/OFF. To retransmit to another wireless console.
4. Press ( + ) or ( − ) to set the ON (to receive from that station) or OFF.
5. Press GRAPH to change station type: ISS, TEMP, HUM, TEMP/HUM, WIND,
RAIN, LEAF, SOIL, LEAF/SOIL.
6. Press ( < ) or ( > ) to view the other station IDs.
7. Repeat steps 4-6 to set multiple stations.
To retransmit data to another wireless console:
1. To enter the setup screen, press and hold DONE and then press ( - ).
2. Press DONE twice to advance to the RESTRANSMIT message in Setup Mode.
3. Press ( + ) or ( − ) to set the retransmit capability ON or OFF.
4. Press ( < ) or ( > ) to advance to the next free station ID.
5. Press and hold DONE to return to the current weather screen.
Press TEMP to toggle between:
• Outside Temperature (0°F, 0.0°F, 0°C, 0.0°C )
• Inside Temperature (0°F, 0.0°F, 0°C, 0.0°C )
• Temp 2–8 (0°F, 0.0°F, 0°C, 0.0°C ) if you have one or more Tempera-
ture and/or Temperature/Humidity Stations.
• Soil Moisture (centibars) & Soil Temperature (0°F, 0.0°F, 0°C, 0.0°C )
if you have a Soil Moisture Station. Continue to press TEMP to dis-
play each soil moisture/temperature pair. Maximum is four pairs.
Press 2
ND
& UNITS to change unit of measure.
All temperature-related readings (inside and outside temperature, wind
chill, heat index, and dew point) will read in the same unit of measure.
Changing one from °F to °C (or vice versa) changes all others.
For temperature from Leaf Wetness Station, see "HUM."
6 27