DAVIS Vantage Vue Quick Start Guide

Connecting a Davis Vantage Pro 2 or Vue to Weather Underground Using a
Weatherlink IP Device
Complete installation of your weather station.
● Davis Support installation diagrams and instructions
Connect the Weatherlink IP device to the Vantage Vue or Vantage Pro 2
console.
Connect the Weatherlink IP to the Internet (plug it in to your router).
● Installation diagram for Vantage Pro 2.
● Installation diagram for Vantage Vue.
Create a free Weatherlink account at www.weatherlink.com.
Click the Add Devices button at the top right corner of the
Weatherlink website.
On the device menu, click the Install button in the
WeatherlinkIP section.
Enter your Station Name. Select the weather station Model. Identify your
Station Usage. Enter your Device ID. Enter your device Key.
● Both the Device ID (DID) and Key are found on the sticker attached to the Weatherlink IP device.
Confirm your station is communication with the Weatherlink website.
● Verify data appears on the website.
● Helpful Tip:  If no data appears, power cycle the display console after connecting the Weatherlink
IP device.

DAVIS Vantage Vue Specifications

General

Wind Speed Range	2 to 150 mph (3 to 241 km/h)
Rain Collector Resolution	0.01 in (0.2 mm)
Rain Collector Type	Tipping bucket
Update Interval	2.5 seconds
Temperature Accuracy	±1°F (±0.5°C)
Humidity Accuracy	±3%
Wireless Transmission Range	up to 1000 ft (300 m)
Humidity Range	1 to 100% RH
Wind Direction	0 to 360°
Wind Direction Accuracy	±3°
Power Supply	Solar-powered with battery backup
Console Display	LCD with backlight
Power (Console)	3 C batteries or AC adapter
Wind Speed Accuracy	±2 mph (±3 km/h) or ±5%, whichever is greater
Solar Radiation Sensor	Not included
UV Sensor	Not included
Rain Measurement Accuracy	±4% at rates up to 2 in (50 mm) per hour